Maintenance; Cleaning And Care; Repairs; What To Do If - Gastro-Cool GCDC130 Bedienungsanleitung

10 Maintenance

10.1 Cleaning and care
If the appliance is unclean, proceed as follows:
1. Before beginning with repair or cleaning works make sure the device has
been disconnected from power socket (pull the power plug!!!) and has
cooled down.
2. Clean the interior (including the rear wall and bottom) with warm water
and a mild cleaning product. Do not use any aggressive cleaning products!
3. Dry all surfaces carefully.
4. After cleaning reconnect the refrigerator to the mains supply.
5. Never clean the appliance with steam cleaning equipment.
6. R egularly clean the refrigerator and also check the condensation water
outflow hole.
7. If the light is damaged, it must be replaced with a same size, power and shape
one and must be replaced by the manufacturer or its service agent.
8. We recommend annual cleaning of the condenser to maintain
the performance.

11 Repairs

WARNING:
Repairs to electrical equipment may only
!
be carried
A repair carried out incorrectly or unprofessionally puts the
user at risk and leads to the warranty becoming invalid!
!
WARNING:
Do not damage the refrigerant circuit.
WARNING:
Do not use electrical appliances inside the
!
food storage compartments of the appliance, unless they
are of the type recommended by the manufacturer.
34
out by our customer service.
12 What to do if...
Solutions to problems
The design of the appliance guarantees interruption-free operation and a long
working life. If nevertheless a fault does occur during operation, check whether
this can be traced back to an operating error.
Any subsequent faults can be eliminated by yourself by checking the possible
causes:
Fault Possible Causes
The appliance is Is the mains plug in the
not cooling socket?
Has the fuse in the socket
been triggered?
The appliance Is the appliance standing
is noisy when vertically or horizontally?
operating
Water is lying on Has the temperature
the bottom of the regulator been set correctly?
refrigerator
Is the condensation water
channel blocked by dirt?
Is the condensation drain
disrupted by bottles on the
bottom?
The appliance Is the appliance ventilation
is not cooling blocked?
correctly
Wet glass The device temperature is
set too cold?
The air humidity in the
Unit is too high?
Measures
Insert the mains plug correctly
in the mains socket, switch on
the fuse, if required call for
expert assistance.
Adjust the appliance using
the feet.
The flow noises in the
refrigerant circuit are normal.
Correct the temperature
regulator setting.
Clean the outflow opening with
a pipe cleaner or a small brush.
Place the bottles on a shelf.
Clear the ventilation slot,
position the appliance freely.
Set the temperature slightly
higher.
35