Operation; Switching The Appliance On; Setting The Temperature; Noises During Operation - Gastro-Cool Cool-Tool Bedienungsanleitung

9

operation

9.1 Switching the appliance on

In order to switch on the appliance push the mains plug into the socket.

9.2 Setting the temperature

The temperature can be set at from 0°C to 10°C. It is set by the knob.
0
noTE
Please note that the temperature will change depending on the
ambient temperature (installation site), the frequency of opening
the door and the fittings.
IMPoRTAnT
high room temperatures (such as e.g. on hot summer days)
and a cold temperature setting can lead to continuous
refrigerator operation. The reason for this is that the
compressor has to run continuously in order to maintain the
low temperature in the appliance. The appliance is not able to
defrost automatically because this is only possible when the
compressor is not running. Therefore, a thick layer of frost or
ice may form on the rear interior wall.
30
Downloaded from www.Manualslib.com manuals search engine

9.3 noises during operation

normal noises
• Humming – the noise is caused by the compressor during operation.
It is loud when it switches on or off.
• Liquid noise – caused by the refrigerant circulating in the unit.
• Clicking noises – the temperature regulator switches the compressor
on or off.

10 Defrosting / Switching off

During the cooling and defrosting phases a thin layer of ice or drops
of water form on the inner wall. The condensation water flows into
a collecting tray and evaporates. Please ensure that the outflow
channel is not blocked. It can be cleaned carefully with a pipe cleaner.
Your refrigerator does have automatic defrosting, but if a thicker
layer of ice forms in-side the appliance – if you occasionally defrost it
by hand – proceed as described under point 11.1. Optionally, in order
to accelerate defrosting you can place a bowl with hot water in the
appliance or use a hairdryer.
31