Sharp K-71F28AM2-EU Bedienungsanleitung Seite 17

on the Temperature display. This can be
adjusted using the PLUS and MINUS
sensor buttons on the side of the display.
The temperature can be adjusted within
the range of 50°C to 275°C.
After the desired function has been
selected, and the temperature and time
are set, touch the START/STOP sensor
to start the oven function operation.
Adjusting the Time of Day
When the oven has been installed, the
time of day must be set according to the
following instructions.
Touch the ON/OFF sensor to switch the
oven on and enter "WAIT" mode. During
this mode, touch the MODE sensor button
until the time is selected. The symbol for
the time will illuminate on the left side
and you can adjust it using the PLUS
and MINUS sensor buttons. To complete
the time adjustment, touch the MODE
sensor once again.
The time will only have to be set again if
the appliance is disconnected from the
power supply for a long period of time.
Adjusting the Cooking Time
The cooking time can be adjusted during
"WAIT" mode or during "OPERATING"
mode.
Adjusting the Minute Minder
Touch the MODE sensor until the Minute
Minder symbol illuminates on the Time
display and "00:00" appears. Adjust
the desired time period for the warning
signal using the PLUS and MINUS sensor
buttons while the symbol is flashing. When
you have completed the adjustment, do
not press any buttons for a few seconds,
then the Minute Minder timer will be set.
When the timer reaches zero, an audible
warning will sound, and the Minute Minder
symbol and "00:00" will flash on the
Time display. Press any button to stop
the audible warning and the symbol will
disappear.
Adjusting the Cooking Duration Time
This function helps you to cook for a
fixed period of time. Prepare the food
for cooking and put it in the oven. Then,
select the desired cooking function and
the temperature. Touch the MODE sensor
button until you see the Duration Time
symbol on the Time display. Set the
required cooking period using the PLUS
and MINUS sensors while the timer is in
this position. When you have completed
the adjustment, wait until the current time
of day is displayed and until the Duration
Time symbol remains illuminated.
When the timer reaches zero, the oven will
switch off, an audible warning will sound
and the Duration Time symbol will flash
on the Time display. Touch any sensor on
the control unit to end the sound.
Adjusting the Cooking End Time
This function is used to begin cooking
after a certain period of time and for a
specific duration of time. Prepare the food
for cooking and put it in the oven. Then,
select the desired cooking function and
the temperature.
Touch the MODE button until you see the
Cooking Duration Time symbol on the
Time display. Set the required cooking
period using the PLUS and MINUS sensor
while the timer is in this position. When
you have completed the adjustment, wait
until the current time of day is displayed
and until the Cooking Duration Time
symbol remains illuminated.
EN - 14