eta ELA mini Bedienungsanleitung Seite 15

B – removable stand
B1 – central connector
* The steam sensor ensures automatic switch off the appliance after reaching the boiling
point.
III. INSTRUCTIONS FOR USE
Before the first use, fill the electric kettle with clean water to the maximum level, turn
it on and let the water boil. Then pour out the water and repeat the procedure several
times (at least five times).
APPLICATIONS
Open the lid A5 by pressing the lock button A6. Fill the kettle with drinking water. Close the
lid by snapping. Put the electric kettle on the stand and turn it to the I position by the A1
button. Function of the electric kettle is signaled with the control light A2. After boiling the
appliance switches off automatically. Before reaching the boiling point, you can switch off
the appliance by turning the A1 button to the 0 position.
– When heating water, the lid must be closed, otherwise the steam sensor will not be
working.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the
electric kettle. In the case of tilting the electric kettle with hot water there is a risk of
scalding. Therefore do not tilt the electric kettle.
– Make sure the sieve and its cover is fit on thorougly in the upper part of the kettle in
order that it does not fall to the bottom!
– If the kettle was removed from the stand during boiling, remains in ON position.
This means that if you put it back on the stand, it will immediately continue in heating.
– Recommendation: When the kettle is not used, do not place it on the stand connected
to the mains. If you are going not to use the kettle for a long time, unplug the power
cord from the wall socket.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord
out of the socket! Clean the kettle only when it is cooled down! Do not use rough
and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other
solvents)! The casing of the electric kettle and the heating bottom is made of top-quality
stainless steel, but in common use, impurities from water get stuck on them (water scale),
particularly above the heating element. It is not rust or another material defect of the
kettle container and the appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle
to about one half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount
of water. Place the electric kettle on the stand and turn it on. Before boiling, turn off the
kettle, let the solution take effect for about 10 minutes and then pour it out. Clean the
kettle thoroughly with clean water. Repeat the whole procedure if the kettle is too soiled.
Clean the electric kettle regularly!
B2 – power cord
ATTENTION
15 / 31
GB