Radson UFH - RF Bedienungsanleitung Seite 9

Put your thermostat in the off mode on the main
display.
o
If the RF learning is not made correctly,
check the installation (antenna
connection, supply voltage...)
o
On the receiver you can exit the RF init
mode or configure another thermostat.
(Please refer to the receiver leaflet for
this)
Now you can check the RF distance, go to
the room which must be regulated. Put your
thermostat on the final position (On the wall
support or on the table support), then put the
thermostat on the comfort mode (setting
temperature 35°C). Close the door and go to
the receiver to check if the new status of the
thermostat has received.
If it‟s good, adjust your setting
o
temperature as you want.
I it‟s not good, check the installation
o
(Antenna position, distance...)
9