Radson UFH - RF Bedienungsanleitung Seite 8

4 How to learn your RF thermostat with
the RF receiver
To learn (*) the RF thermostat with the receiver
you must put the receiver in "RF init" mode
(Please refer to the receiver leaflet).
Once, on the thermostat go to the Auto
operating mode with the (OK) key
o
After Press simultanetely the (-) & (+) key
during 5 sec, then this display must be
appear,
o
The thermostat will send now the RF
signal to the receiver. Check on the
receiver the good configuration.
o
If the RF learning between the thermostat
and the receiver is good, on the
thermostat go to the parameter number 09
and press (OK) to come back to the main
display.
8