Sharp K-71V28AM2-EU Bedienungsanleitung Seite 21

The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
7
6
4
3
2
1
• Insert the accessory to the correct
position inside the oven.
• Allow at least a 1 cm space between the
fan cover and accessories.
• Take care removing cookware and/or
accessories out of the oven. Hot meals
or accessories can cause burns.
• The accessories may deform with heat.
Once they have cooled down, they will
recover their original appearance and
performance.
• Trays and wire grids can be positioned
on any level from of 1 to 7.
• Telescopic rail can be positioned on
levels T1, T2.
• Level 3 is recommended for single level
cooking.
• Level T2 is recommended for single
level cooking with the telescopic rails.
• Level 2 and Level 4 are recommended
for double level cooking.
• The turnspit wire grid must be
positioned on Level 3.
• Level T2 is used for turnspit wire grid
positioning with the telescopic rails.
****Accessories may vary depending on the
model purchased.
CLEANING AND
MAINTENANCE OF YOUR
OVEN
CLEANING
5
T2
Before starting to clean your oven, be
T1
sure that all control buttons are off and
your appliance is cooled off. Unplug the
appliance.
Do not use cleaning materials conta-
ining particles that might scratch the
enamelled and
painted parts of your oven. Use cream
cleaners or liquid cleaners, which do not
contain particles. As they might ahrm
the surfaces, do not use caustic cre-
ams, abrasive cleaning powders, rough
wire wool or hard tools. In the event the
excess liquids spilling over your oven
should burn, it may cause a damage to
the enamel. Immediately clean up the
split liquids. Do not use steam cleaners
for cleaning the oven.
Cleaning the interior of the
oven
Make sure to unplug the oven before
starting to clean it. You will obtain best
results if you clean the oven interior
while the oven is slightly warm. Wipe
your oven with a soft piece of cloth
dampened with soap water after each
use. Then wipe it again, this time with a
wetted cloth, and wipe it dry. A complete
cleaning using dry and powder type cle-
aners. For product with catalytic enamel
frames, the rear and side walls of
EN - 18