Set Cooking Level With And Without Heat Boost; Turn Off Individual Heaters; Timer Function - Sharp KH-6V09CS00-EU Bedienungsanleitung

If is pressed, the buzzer signal sounds
and the Dual Zone Indicator is statically
on. If is pressed once again, another
signal is heard and the triple heater is
switched on. The Triple Zone Indicator
will be illuminated and the triple zone will
be energized.
After pressing
zone of the heater will be switched off
again. Each operation causes a status
change of the dual/triple zones following
in this manner (Dual zone on, triple zone
on, all extended zones off, dual zone on,
triple zone on, dual zone on, etc. ...)
Set Cooking Level With and Without Heat
Boost. All heaters are equipped with a
heat boost functionality.
If the heat boost is active, then the heater
will be operated with maximum power for
the period of the heat boost time, that is
dependent on the selected heat setting.
This is indicated through a flashing ´A`,
alternating with the heat setting value (e.g.
0.5 sec ´A` and 0.5 sec ´9`) in the heater
display. Once the heat boost time ends,
only the heat setting will be indicated.
If the heat boost should be used for a
heater, touch or slide the heat to level 0,
then touch heat level 9 again. After setting
the heat to level 9, ´A` will be indicated
alternating. This means that level 9 and
the heat boost is active now.
once again, the triple
The heat boost can be turned off by sliding
your finger across the panel until heat
setting ´0` appears.

Turn Off Individual Heaters

A selective heater can be turned off with
3 different ways:
• Simultaneous operation of the right
and left part of the slider button
• Reduction of the heat setting to ´0` by
press the right and the left part of the
slider button
• Use of timer turn off function for the
corresponding heater

Timer Function

The timer provides the following features:
The control can run a max. of 4 heater
assigned timers and 1 minute minder
(which is not assigned to any heater)
simultaneously. All timers can be used
only in B-Mode. A heater timer can only
be assigned to an active heater, running
in levels between 1-9. The minute minder
is independent of any heater.
In order to use both functions, the timer
function must be activated by the Active/
Inactive Timer button
Pressing
the heaters, the control proposes the
minute minder (no Cooking Zone Indicator
is flashing, they are all on or off).
EN - 11
.
.
for the fist time after activating
.