Herunterladen Inhalt Inhalt Diese Seite drucken

Residual Heat Indicator; Safety Systems - K&H VC-3403DB Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Power
Press the button
for the rear cooking zone or button
for the front cooking zone.
With the buttons „1-9" you can change the power levels or by pressing the "0", switch off the relevant
cooking zone. The only difference is that the rear heating zone have two heating circles, you can
choose the inner heating circle for a smaller pot or for lower power or the whole bigger heating circle
by pressing the heating zone selection button
.
Rear cooking zone up to max. 2.200W
Front cooking zone up to max. 1.200W

Residual heat indicator:

When the hob has been operating for some time, there will be some residual heat.
The residual heat indicator warns for each cooking zone separately with "H" symbol.
Timer
After you have selected the power press the timer key
.
Timer confirmation:
With repeated pressing onto timer key choose one or two zones you want to set
as the LED light showing. The display shows "00". With the keys "0-9" set the time in 1-minute steps
(max. 99 min.) After 5 seconds no number level key be pressed, the time will start timing and the
display will indicate the countdown time until to "00". If the two zones has been set different time, the
display will indicate the less time setting zone.
Timer cancellation
By pressing onto timer key choose the zone you want to cancel the timer. Then press number level
key"0" two times and the timer function will be cancelled.

Safety systems

In order to protect the electronics from overheating if the control unit detects excessive heat it will
switch off the hotplate closest to the sensors and the letter H will appear on the display. This hotplate
can be activated when the temperature of the electronic unit returns to normal.
Each hotplate is equipped with an interior temperature limiter that switches off the hotplate if the
radiant surface is heated excessively.
If any cracks appear in the radiant surface, immediately disconnect it from the mains. Do not use any
part of the cooktop until a new radiant surface has been fitted.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis