Attaching The Work Piece Support Brackets; The Longitudinal Fence; Connecting The Dust Bag; Checking The Cutting Angle - Westfalia 64 01 77 Bedienungsanleitung

Please Notice: Before undertaking any assembly or maintenance work
on the machine, please disconnect the power supply.
You can permanently mount the mitre saw on a work bench or table. For this
there are four mounting holes in the base plate (part no. 1). If you want to keep
the machine mobile, attach the included rubber feet (Z
Attaching the Work Piece Support Brackets (P)
Both work piece support brackets (P)
are inserted into the holes at the sides
of the base plate (part no. 1) and fixed
in place with the support clamps (Z
The Longitudinal Fence (J)
A longitudinal fence (J) is included
with the unit.
It makes work easier if you need to
cut several work pieces to the
same length.
The longitudinal fence (J) is slid
into one of the work piece support
brackets (P) and clamped down at
the intended location with the screw.
Connecting the Dust Bag (B) or a Dust Extractor
A dust bag (B) is included with the machine.
1. Attach the dust bag to the flange behind the cutting assembly.
2. Always use the dust bag or, preferably, a dust extractor.

Checking the Cutting Angle

1. Before the first use, check the correct
angle of the saw blade.
2. Adjust the saw blade in the upright
position and lock it in place with the
locking lever (T).
Using
).
3
14
) to the base plate.
1
P
Z
3
Z
1