Electrolux WTGL4E200 Benutzerinformation Seite 30

30 www.electrolux.com
Problem
The appliance does not
fill with water and drain
immediately.
The appliance does not
drain the water.
The spin phase does not
operate or the washing
cycle lasts longer than
usually.
There is water on the
floor.
You cannot open the
appliance door.
Possible solution
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to "êare and cleaning".
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is cor-
rect.
Make sure that the drain hose is in the correct position. The
hose may be too low.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the drain filter is not clogged. êlean the filter,
if necessary. Refer to 'êare and cleaning'.
Make sure that the connection of the drain hose is correct.
Set the drain programme if you set a programme without
drain phase.
Set the drain programme if you set an option which ends
with water in the tub.
Set the spin programme.
Make sure that the drain filter is not clogged. êlean the filter,
if necessary. Refer to 'êare and cleaning'.
Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.
Make sure that the couplings of the water hoses are tight
and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct
quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure that the appliance receives electrical power.