Trouéleshooting - Electrolux WTGL4E200 Benutzerinformation

0° ê, remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. êlose the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install
the inlet hose again.
15. TROUéLESHOOTING
WARNING!
Refer to Safety chapters.
15.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service êentre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly.
15.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
•
•
•
•
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end
of countdown.
Deactivate the êhild Lock function if it is on.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
WARNING!
Make sure that the
temperature is more than 0
°ê before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance does not drain
the water.
- The appliance door is open or
not closed correctly. Please check the
door
- The mains supply is unstable.
Wait until the mains supply is stable.
- The anti-flood device is on.
Disconnect the appliance and close the
water tap. êontact the Authorised
Service êentre.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH 29