Product Description; Intended Use; Authorized Users; Preparation By The User - Bosch VLH 4345 LA Originalbetriebsanleitung

en 26 | VLH 4x45 LA | Product description
5.

Product description

5.1

Intended use

The type approved lifting platform VLH 4x45 LA is
intended solely for the following applications:
R
Lifting of passenger/motor vehicles using the
runways.
R
Lifting of passenger/motor vehicles using the wheel-
free scissor lift.
R
Wheel alignment using the sliding plates
(optional turntables required).
Compliance with the limit values for loadbearing
capacity and load distribution must always be ensured.
Property
Runway Length
Runway Width
Weight (without accessories)
The following regulations must be observed when
starting up and operating lifting platforms:
R
Rules for lifting platform operation (BGR 500)
R
Basic principles for testing lifting platforms
(BGG 945)
R
Rules for keeping the inspection log (BGG 945-A2)
The lifting platform is not to be used as a crane or as
a support for other lifting mechanisms (e.g. block and
tackle).
The lifting platform is designed such that people
can stand under the loadbearing elements. It is not
equipped to permit walking on the lifting platform or
for conveying people.
Erection of the lifting platform is prohibited in
explosion and fire hazard areas, outdoor areas and in
damp atmospheres (e.g. washing shops).
The original operating instructions must be kept in
a conspicuous, constantly accessible location near
the lifting platform. All the above regulations must be
heeded as well as the applicable rules on work safety
and accident prevention.
|
1 689 989 097 2017-07-19
VLH 4245 LA VLH 4345 LA
4810 mm 5070 mm
500 mm 630 mm
1600 kg 2000 kg
3530 lb 4413 lb
5.2

Authorized users

Only users aged 18 or above who have been instructed
on how to operate the lifting platform and have proven
their ability to do so to the owner are to be entrusted
with unsupervised operation of lifting platforms. The
task of operating the lifting platform must be expressly
assigned to users by the owner. Authorization to
operate lifting platforms must be granted in writing.
Before loading a vehicle onto the lifting platform, users
should study the original operating instructions and
familiarize themselves with the operating procedures in
several trial runs.
5.3

Preparation by the user

5.3.1

Space requirements

Refer to Appendix A for the dimensions of the lifting
platform.
There must also be a clearance of at least 1 meter
between the lifting platform and fixed elements
(e.g. wall) in all lifting positions.
There must be sufficient space at the ends of the lifting
platform for driving vehicles on and off.
i
To stop vehicles colliding with the ceiling, it is
advisable to fit an overhead light barrier in low-
ceilinged buildings.
5.3.2 Foundation and connections
The user must have the following work performed
before erecting the platform:
R
Construction of the foundation following
consultation with Bosch customer service or an
authorized service agent.
R
Routing of the wiring to the installation location.
The user must provide fuse protection for the
connection.
R
Routing of the compressed air connection to the
installation location. The user must install a service
unit upstream of the connection.
i
Refer also to the corresponding information in the
commissioning instructions.
Robert Bosch GmbH