Operating; Intended Use; Before First Use; Material Preparation - Westfalia 81 34 30 Bedienungsanleitung

Intended Use

The air texture spray gun is intended for processing of wall finishes or for the
use with synthetically coating material for inner and outer walls. The air texture
spay gun can only be used in connection with a pressure vessel which delivers
the coating material to the air texture gun.
The intended use also includes an operation following the operating
instructions. Any use beyond these parameters (different media, applying
force) or any changes (reconstruction, no original accessory) can lead to
serious risks and is not regarded as intended use.

Before first Use

Unpack the air texture spray gun and check all parts for any damage in transit.
Dispose of packaging materials or store them out of reach of children. Plastic
bags etc. may become a deadly toy for children.

Material Preparation

Mix the coating material in a separate container. Make sure the coating
material is stirred evenly and is clear of lumps.
Select the right nozzle for the used coating material. For selecting the right
nozzle the grain size and the fineness of the spray pattern are important
factors.
Do not fill coating material up to the rip into the pressure vessel. Make sure to
properly close the pressure vessel. Always observe all instructions of the
pressure vessel manual.

Application

without Grain
Fog
Acoustic
Orange Peel
Splatter Coat
Knock-Down
Elastomers
Plastics
EIFS Exterior Insulation
Finishing System

Operating

Nozzle Size
3 – 4 mm
4, 6, 8 – 10
3 – 4 resp. 4 – 8 mm
6 – 8 resp. 6 – 10 mm
8 – 12 mm
8 – 12 mm
8 – 10 mm
8 – 12 mm
12
Air Volume
high
medium to high
medium to high
low to medium
low
high
high
high