Delete The Command Signal (House Code); Adjusting The Light Sensor (Lux Regulator); Replacing The Illuminant - Westfalia 96 11 28 Bedienungsanleitung

Delete the Command Signal (House Code)

If you decide for some reason to delete the transmission command between
the motion detector, the radio switch or the remote control together with the
lantern, so the lantern will not turn on and off, follow the below mentioned
steps:
1. Press the learning key for at least 3 seconds and release the key. The
built-in LED starts flashing.
2. Press the learning key again for approx. 6 seconds. First the LED turns off
and than it starts flashing and indicates that all codes are deleted.
Adjusting the Light Sensor (LUX-Regulator)
The built-in light sensor has a photocell that detects daylight and darkness.
Turn the LUX regulator (6) towards T, to have the lantern turning on the light
during day. Turn the regulator towards , to have the lantern activated only at
night.
If the lantern turns on in daylight position, turn the regulator towards
However, if the light is not activating during night time turn the regulator in the
opposite direction.
Please note that the manual override function – using the remote control and
the radio switch - is not impaired by the light adjustment. Therefore you will
always be able to switch on and off the lantern at day and night with the
remote control and the radio switch.

Replacing the Illuminant

Make sure mains power is voltage-free before changing the illuminant!
To switch off the lantern by using a transmitter (remote control or radio
switch) is not sufficient!
Attention! The illuminant becomes hot during operation! Allow the
illuminant to cool down before replacing.
Be very careful when handling broken illuminants.
Using
17
.