Deactivating The Motion Detector - Westfalia 96 11 28 Bedienungsanleitung

Using
Learning the lantern with the remote control, Type SR102
Hold the remote control and the lantern close together. Hold the learning key
pressed that way (preferably form the side) to be able to notice the status of
the LED. Press down the learning key until the LED starts flashing. Now you
have totally 3o seconds to emit the command signal. First select the
transmission range 1, 2 or 3. Decide if the lantern should be operated with the
pair of keys of group A or group B. Hold the selected AUS/OFF key pressed,
until the LED of the learning key and the LED of the remote control turn off.
The command signal is emitted.
Learning the lantern with the motion detector, Type SP101
Hold the motion detector and the lantern close together. Hold the learning key
of the lantern from the side and observe the status of the built-in LED. Keep
the learning key pressed as long as the LED starts flashing. Now press the
contact switch on the bottom side of the motion detector, until the LED of the
lantern starts glimmering and than turns off. This indicates that the command
signal is emitted.

Deactivating the Motion Detector

Despite of day and night you can use the remote control or the radio switch to
deactivate the motion detector.
Manual Override with the remote control, Type SR102
When pressing the EIN/ON key the lantern will light up continuously even if the
time setting of the motion detector is adjusted to short-time operation. When
pressing the AUS/OFF key you will switch off the lantern. Afterwards the
lantern can be switched on with the motion detector or by using the remote
control or the radio switch.
Manual Override with the radio switch, Type AC122
When pressing the ON section of the rocker switch the lantern will light up
continuously even if the time setting of the motion detector is adjusted to short-
time operation. When pressing the OFF section of the lantern you will switch
off the lantern. Afterward the lantern can be switched with the motion detector
or by using the remote control or the radio switch.
16