Learning - Westfalia 96 11 28 Bedienungsanleitung

6. Use the oval holes (13) for mounting the cover
on the wall. Please observe the positioning
symbol „UP" (9); this part of the cover has to be
up.
7. Connect the cables of the lantern with the
terminals as shown in the drawings on pages
13 and 14.
8. Reattach the front part of the lantern on the
cover and screw the lantern with the fixing
screws (11).
9. Insert the illuminant and mount the glass
housing resp. the lantern lid on the lantern.
As soon as the lantern is connected to power
mains, the LED-learning key (7) will flash every
3 seconds to indicate that no command signal is
emitted.

Learning

The radio controlled lantern serves as a receiver. The lantern can be switched
on and off with one or several transmitters.
The remote control, type SR102, Art. 96 11 02,
the radio switch, type AC122, Art. 96 11 10 and
the motion detector, type SP101, Art. 96 11 51
can be used to switch on and off the lantern. To enable the lantern to
communicate with the transmitter, first a command signal has to be emitted.
Learning the lantern with the radio switch, Type AC122
Hold the radio switch and the lantern close together and press down the
learning key of the lantern (preferably from the side) to be able to notice the
status of the built-in LED. Press the learning key as long as the LED of the
lantern starts flashing. Press the OFF section of the rocker switch for approx.
3 seconds until the LED of the lantern starts glimmering and than turns off.
Now the command signal is emitted.
Using
15