Using The Sanding Paper Pads - Westfalia TD8501 Bedienungsanleitung

Using the Sanding Paper Pads

Choose the sanding paper pad according to the material being worked. Use
sanding pads with a 40 resp. 60 grain for rough sanding and on uneven surfaces.
Use the finer grain of 120 for smoother finish.
1. Remove the dust protection rubber caps (4)
from the bottom of the machine. Store the
rubber caps in a save place. The rubber caps
are strictly required for other application!
2. First mount the dust extraction adaptor (15) on
the machine, as shown in the figure. The dust
extraction adaptor has to be firmly mounted
with three hex screws on the machine. For
tightening the hex screws use the small, in-
cluded hex key (17). Do not overtighten the hex
screws. Afterwards mount the sanding pad
holder (11) on the adaptor and tighten the tool
retaining bolt (7) with the included T-type hex
key (18).
3. Attach the sanding paper pad on the sanding
plate and firmly press the whole sanding pad
down.
4. First, insert the extractor nozzle of the dust
extraction hose (16) into the dust extraction
adaptor (15) and lightly turn the hose in order to
lock. The dust extraction adaptor and the hose
are equipped with bayonet lock. Connect the
other end of the hose with the vacuum cleaner.
Always use the dust extraction hose and a dust
mask when sanding hazardous materials.
Forced dust extraction is essential if the mate-
rial that has to be sanded is slightly damp.
5. Push the ON/OFF switch (1) forward and
switch on the vacuum cleaner. Hold the ma-
chine firmly with your hand when using and
whenever possible, move the machine in a
steady motion parallel to the surface. By doing
so, you will avoid grooves or hollows on the
surface.
Operation
13
2.
1.