Using The Saw Blades; Maintenance And Cleaning - Westfalia TD8501 Bedienungsanleitung

Using the Cutting Blades
Only use sharp cutting blades to achieve a
straight cut and to avoid overloading the multi
tool.
Use the round and the straight cutting blades
for cutting timber products or plastics. The
cutting purposes are cross cuts, drop cuts or
close cuts, such as cutting-back door frames.
1. Insert the dust protection rubber caps into
the openings!
2. Mount the new saw blade on the tool
holder, as shown in the figure. The saw
blade has to lie flat on the work piece. The same mounting procedure applies
for the straight saw blade (12).
3. Make sure the saw blade is aligned correctly. The four opening of the saw
blade have to be inserted into the four pins on the tool holder.
4. First place the washer on the saw blade and tighten the saw blade and the
washer with the retaining bolt. Do not overtighten the retaining bolt.

Maintenance and Cleaning

Always pull the battery from the multi tool before carrying out any work on the
machine!
Clean the dust extraction adaptor and all connections from time to time with a
stiff brush. Use a lightly moistened cloth to clean the housing of the machine.
Do not use solvents, abrasives or aggressive chemicals for cleaning.
Make sure liquids of any kind cannot enter the housing of the multi tool.
Operation
15