Mounting The Sanding Pad Holder; Attaching The Sanding Paper Pad To The Sanding Pad Holder; Attaching The Dust Extractor; On/Off Switch - Westfalia 11 34 15 Bedienungsanleitung

Mounting the Sanding Pad Holder

1. Attach the sanding pad holder (9) to the tool
holder. Attach the small flange (8) with the convex
side upwards. Fasten the sanding pad holder with
the socket screw on the tool holder. By doing this,
the flange applies pressure on the sanding pad
holder.
2. Tighten the socket screw with the included Allen
spanner (5) hand-tight.

Attaching the Sanding Paper Pad to the Sanding Pad Holder

The sanding pad holder is equipped with a hook and loop pad, so you easily and
conveniently can change the sanding paper pads (4).
Keep the adhesive fabric of the sanding pad holder free from dirt and dust, so the
adhesive fabric will work as desired.
1. Position one corner of the sanding paper pad to the pad holder and firmly
press it down. For optimal dust extraction, make sure the holes in the sanding
paper pad and in the sanding pad holder match.
2. To remove the sanding paper pad, grasp one edge and pull it off the sanding
pad holder.

Attaching the Dust Extractor

Always attach a dust extracting device when using the multi-function tool for
sanding.
1. Attach the dust extracting adaptor (3) into the provided opening on the
housing.
2. Connect the suction hose to the dust extracting adaptor.

ON/OFF Switch

1. To switch on the multi-function tool, push the ON/OFF switch (1) forwards.
2. To switch off the tool, pull the ON/OFF switch back.
Operation
13