Removing The Bobbin Case; Threading The Bobbin Case - Medion MD 11836 Bedienungsanleitung

Removing the bobbin case

• Remove the table extension.
• Turn the hand wheel (10) to move the needle to its highest po-
sition, move the sewing foot to its highest position and open the
bobbin case cover (18) as illustrated.
• Open the rocking arm of the bobbin case and remove this from
the machine.
• When you let go of the rocking arm, the bobbin falls out of the
bobbin case.

Threading the bobbin case

• Hold the bobbin between the thumb and index finger of your
right hand and leave about 15 cm of the thread hanging out.
• Hold the bobbin case in your left hand and put the bobbin in the
bobbin case.
• Put the end of the thread into the slit on the edge of the bobbin
case.
• Now pass the thread through the tension spring and into the
thread hole. Make sure that around 15 cm of the thread is han-
ging out of the bobbin.
EN
EN-11