Maintenance And Cleaning; Replacing The Sewing Light Bulb; Replacing The Needle - Medion MD 11836 Bedienungsanleitung

M
AINTENANCE AND CLEANING

Replacing the sewing light bulb

Replacing the needle

EN-30
Before carrying out any maintenance, cleaning or replacement
work, please always turn off and unplug the machine.
You switch the sewing light on and off using the main switch (13).
• For information on opening the front flap (21) see page 15.
• You can now swing the front flap (21) out to the left.
• Replace the bulb.
• Close the front flap (21) and screw it tight.
NOTE
The maximum permitted light bulb power rating in 15W.
Light bulbs are available from specialist retailers.
• Turn the hand wheel (10) towards you until the needle has rea-
ched its highest position.
• Loosen the needle holding screw by turning it towards you.
• Remove the needle from the needle holder.
• Insert a new needle with the flat side facing backwards. Push the
needle upwards until it can go no further.
• Tighten the needle holding screw again.
NOTE
Needles are available from specialist retailers.
For information on types and thickness, please see the table for fa-
bric, thread and needle data on page 40.