Medion MD 11836 Bedienungsanleitung Seite 97

EN-10
• Place the bobbin on the bobbin spindle (8), with the side of the
bobbin containing the end of the thread facing upwards. Move
the bobbin spindle (8) to the right towards the winding stop (9)
until it audibly clicks into place.
• Hold on to the end of the thread and press the foot pedal. Once
some thread has been wound on to the bobbin, let go of the end
of the thread. Wind thread on to the bobbin until the bobbin
spindle (8) automatically stops.
• Move the bobbin spindle (8) to the left and remove the bobbin.
• Cut the thread.
• Set the switch in the hand wheel (10) back to the needle symbol.
The needle will now move again when you press the foot pedal.
If the thread is wound unevenly on the bobbin, you can adjust the
height of the thread guide:
• Open the front flap (21).
• Loosen screw (B) to adjust the height of the thread guide (A).