Werbung
LOADING MOTOR REPLACEMENT
e Replacement
1. Unsolder the leads.
Notes:
Mechanism leads
(material: 8347H)
@ E-Ring (1)
Red +
© 4 Washers
Brown
—
grease
When A (diagram above) is depressed,
the inward thrust must not exceed
2 Screw (2)
5 kg.
Figure 33
D.D. MOTOR REPLACEMENT
e Removel
e Fitting
1. Place the D.D. stator assembly on the bearing
holder.
Note:
Take care not to deform the D.D. shield plate
and D.D. shield insulating plate.
2. Fix the D.D. stator with the 3 brass screws (2.6P
+
12S), using a Philips screwdriver.
Coat with
Cup-Tight Screw
XHPSD 30PO6WSO
Tightening Torque Spec. 5+0.5 kg.cm
VC-483GS,GB,N
video head.
Notes:
D.D. Rotor Fixing Screws
=
D.D. Rotor Ass'y
(DD Roter Ass'y Setting Jig)
D.D. Stator Ass''y
Fixing Screws
-— D.D. Stator Ass'y
enn
re i
b
D
D.D. SHield Insulating
Plate
PZETVO124GEZZ
|e
St
D.D. Motor Shield Plate
PSLDM3437GEZZ
If the gap between the surface
edge of the rotor and the stator is
less than 1.6 mm, assemble the
rotor after inserting a spacer
as shown in the diagram below.
Spacer
D.D. Motor Ass'y
RMoTP1050GEZZ
ay
Ca
PSPAZ0031GEZZ
fe)
Figure 34
21
Werbung
