Yamaha MT3X Bedienungsanleitung Seite 7

Ө Input Jacks 1—6
. These six input jacks (MIC/LINE 1, MIC/LINE 2 and
LINE 3 through LINE 6) accept signals from any
line-level source such as an electronic musical in-
strument or a tape player. MIC/LINE jacks 1 and 2
CHANNELS AND TRACKS
. also accept signals from electric musical instru-
ments such as electric guitars and basses, or mi-
crophones. Inputs 1 through 6 are standard
monaural 1/4" phone jacks. When a source is
plugged into one of these jacks, its signal is sent to
the corresponding channel of the MT3X's mixer.
MIC/LINE Trim Controls (Channels 1 and 2
only) |
The trim controls adjust the sensitivity of the chan-
nel-1 and channel-2 inputs to accept a wide range
of signal levels — from line to microphone. The trim
controls are used in conjunction with the channel-1
and channel-2 faders to set the optimum recording
level with a wide range of sources (see "SETTING
RECORDING LEVELS" on page 17).
These selectors determine whether the input to the `
corresponding mixer channel is the output from the
correspondingly numbered track of the MT3X re-
corder section, or the channel MIC/LINE or LINE
channel OFF. Channels 5 and 6 accept line-level
input only.
@ EQLO & HI Controls
trois function as follows:
Shelving
Shelving
-15
(dB) 20 50 Sk 10к 20
100 200 500 ж 2k
FREQUENCY (Hz)
® AUX 1 and AUX 2 Controls
The AUX controls are used primarily when adding
effects such as reverberation or delays to the
sound of each channel or track. The AUX 1 and
AUX 2 controls on each mixer channel determine
the amount of signal from that channel sent to the
AUX SND 1 or AUX SND 2 jack, respectively. The
AUX SND jacks can be connected to the input of
an external signal processor such as the YAMAHA
SPX900 Professional Multi-Effect Processor (see
"USING THE AUX SEND/RTN LOOPS" on page
22).