Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Current
Parallel connection
Stability
Internal resistance
- static
- dynamic
Recovery time
Ripple voltage
:«0.5
mV
-
r
For series connection according
to "master and slave" system
see under point 3e, chap. II. B.
: Max.
6 A for any value of the out-
put voltage.
: An arbitrary number of sets may
be connected in parallel.
For parallel connection according
to "master and slave" system
see under point 3f, chap. II. B.
: For mains voltage variations of
+ 10 % of the nominal value,
the
fluctuation of the output voltage is
« 0.03 % of the set value or < 2.5 mV.
Whichever is greater applies.
: < 10 mQ for slow changes from no
load to full load.
: For sinusoidal load variations
of
80 % from full load to full load and
a frequency of:
0.1 kHz < 0,010 Q
11
AREAS OOAD
Q
LOW
kHz
O0 07510
100
kHz < 0.100 2
250
kHz «0.100
Q
: < 50 usec for a square-wave load
variation of 80 % from full load to
full load.
By recovery time is understood the
time which elapses between the be-
ginning of the load variation and
the moment after which the deviation
of the direct voltage remains within
the limits determined by the static
internal resistance.
See fig. 6.
Ins.
Werbung
