Hitachi D-900 Bedienungsanleitung Seite 15

at "SOURCE" or the internal playback operation route when the Monitor
switch @0 is.set to '""SOURCE''/''TAPE" during playback operation, are
indicated by lamps, respectively; therefore, the signal route can easily
be confirmed.
Note: Indicator "SOURCE" or ''PLAY" flashes during recording or
playing back operation.
REMOTE CONTROL SOCKET
By connecting the remote controller (Optional extra) to the Remote
control socket @7) , the movement of the tape can be controlled by this
controller.
DOLBY CARIBRATION CONTROL (Method of adjustment)
1. Insert the cassette tape to be used
2. Changeover the Tape selector switches and to match the
cassette tape. Set the Dolby noise reduction switch OFF.
3. Depress the Record button @§) and the Playback button @@ to put the
} deck in recording mode. Set the Monitor switch @): at SOURCE,
depress the DCCS control (3 (test), then adjust the Recording level
control (@) so that the pointer of the level meter indicates 0 dB.
4. Set the monitor switch @) to TAPE and adjust the DCCS controls
(3 of both left/right channels so that the pointer of the level meter
indicates 0 dB.
5. Dolby calibration is now finished. Remove your finger from the DCCS
control (3, and set the Dolby noise reduction swtich (7) at ON to
start recording.
The Dolby circuit will now operate in ideal condition.
* Although it is ideal to change calibration every time the tape used is
changed, in adjustment no trouble occurs actually if it is used in the
same condition as when it was shipped from the factory, therefore
do not touch DCCS controls (3 if you find it troublesame.
MEMORY SWITCH
Set the reset button of the Tape counter (8)at '000' when starting
the recording by depressing the reset button at the side of the Tape
counter (@), and rewind with this switch ) set at ON after finishing the
} recording.
Rewinding stops automatically at the beginning of recording and tape-
heading can be done when the counter shows around "999".
2 CASSETTE INSERTION <
When the Eject button @) is depressed, the cassette holder comes out
toward you gradually. Insert the cassette with the exposed tape down-
wards until it is locked, then close the cassette holder.
For cassette removal, depress the Eject button @i) with the unit in the
STOP mode and the cassette holder opens toward you for easily
removal.
When the cassette is fully recorded or played back, it may be turned
over to side 2 (or B) for an equal time of recording or playback.
English 5