Hitachi D-900 Bedienungsanleitung Seite 13

S POWER (MAINS) REQUIREMENTS.
To Set Power (Mains) Voltage:
1. This unit can be used with a power (mains) voltage of 100 to 110V,
115 to 127V, 200 to 220V or 230 to 250V. |Before operating, be
sure to check your local power (mains) voltage.
2. Turn the Voltage selector to your desired power (mains) voltage with
a screw-driver until the selector clicks.
Notes: 1. Before turning the selector, disconnect the AC power (mains)
lead from the AC outlet with this unit in stop mode.
2. Be sure not to turn the selector with a thin screw-driver, etc.
by force. The selector may be broken and the deck will not
operate.
3. When inserting the mains plug into the AC outlet supplying
100 —110/115—127V, insert the plug with adaptor con-
nected to it.
CONNECTIONS <
This unit is not equipped with a built-in power amplifier; therefore it
must be connected to the stereo amplifier. The connection should
preferably be done using the Line out sockets and Line in sockets -
@5) ; if the stereo amplifier is not provided with a Line out socket and
Line in socket, perform the connection via Record/playback (DIN) socket
. (See diagram).
Note: Do not use the DIN cord and US pin-type cords at the same time.
Insert the AC power (mains) lead plug into the power (mains) socket of
Stereo amplifier or into the convenient AC outlet.
Note: Disconnect the AC power (mains) Jead plug from AC outlet when
the unit is not to be used with AC power (mains) for a long
period of time or you are away from home.
OUTPUT SWITCH
When connected with a stereo system, and when recording terminal
(REC OUT) and playback terminal (TAPE IN) are both connected electri-
cally or when recording with DIN lead, abnormal oscillations may occur
because of the wiring of the stereo system connected.
ON: When connected with a stereo system which causes no abnormal
oscillations.
OFF: When abnormal oscillations occur.
DIN MONITOR SOCKET
To monitor when recording with the supplied DIN lead, connect an
extra optional DIN lead to this socket.
(When set the Output switch @9 to OFF")
TAPE SELECT SWITCH
Equalizer and Bias can be changed over independentiy. When using
ferric oxide tape (Fe203), set the Bias and Equalizer to the LH/NOR posi-
tion; when using chrom oxide tape (CrO2), set the Bias and Equalizer to
the CrO2 position; when using ferric chrom tape (FeCr) tape, set the Bias
and Equalizer to the FeCr position.
In addition, by setting this switch in accordance with the various tapes
sold on the market, full tape performance is obtained.