Part Names; Control Panel; Installing The Printer; Connecting To External Devices - Epson TM-T70-i Benutzerhandbuch

English

Part Names

See illustration

Control Panel

FEED button
This button feeds paper.
PAPER OUT LED
On indicates a paper near end or out. Flashing indicates standby.
ERROR LED
This indicates an error.
(Power) LED
This LED is on when the printer is on.

Installing the Printer

You can install this printer only horizontally.
Fix the printer so that it does not move around when you open the printer cover
and cut roll paper. A tape for fixing the printer is available as an option.
As shown in the illustration
Installing the printer with a tilt of more than 3° may cause the following problems.
❏
Roll paper near end cannot be detected.
❏
The printer cover will not close after installing roll paper.
❏
Roll paper cannot be taken out.
Connecting to a Power Source
Note:
It takes approximately 30 seconds after the printer is turned on until it is ready for
printing.
Use the power switch on the front of the printer to turn the printer on and off.
Make sure the power switch is turned off, and connect the dedicated AC adapter
to the printer, as shown in illustration

Connecting to External Devices

CAUTION:
When connecting external devices to the USB (including Micro-USB)
connectors, follow the precautions below.
• Confirm the rated current of the external devices by checking the
descriptions on the devices or manuals. Do not use a device whose
rated current is unclear.
• Use the UL-approved external devices (only for North American users).
• Connect the external devices only when those total rated current is less than 2.0 A.
When using the printer, make sure the protective cover indicated in the
illustration below fits firmly into place.
4 TM-T70-i User's Manual
.
B
, install the printer with a maximum tilt of 3°.
C
.
D