Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When LAN cables are installed outdoors, make sure devices without proper
surge protection are cushioned by being connected through devices that do
have surge protection. Otherwise, the devices can be damaged by lightning.
Note:
Connecting the optional Wireless LAN Cable Set (OT-WL01) to the USB connector
enables the wireless LAN connection. While connecting via wireless LAN, keep the
Ethernet cable unconnected to the printer.
1.
Connect each cables to the connectors at the back of the printer. See the
illustration below for the positions of the connectors.
Drawer kick-out
connector
USB connectors
(for optional products)
Note: Connectors marked "❋" above are not available currently.
2.
Connect other ends of the cables to external devices.
Arranging the Cables
When installing cables without locking connectors (USB cable and DC 5 V cable)
through the cable exits on the back, fix the cables with the cable band to prevent
the cables from coming off. (See illustration
Note:
When attaching the optional connector cover (OT-CC70), use multiple cable exits
depending on the number of the cables. After installing, make sure the cables are not
pinched by the connector cover.
Installing Roll Paper
1.
Press the lever indicated by the arrow in illustration
2.
Remove the used roll paper core.
3.
Install the roll paper in the correct direction, as shown in illustration
4.
Pull out some roll paper as shown in illustration
between the paper guides.
5.
Close the printer cover, and make sure that the roll paper is properly installed
between the paper guides.
6.
Tear off the roll paper as shown in illustration
Analog RGB
connector ❋
Ethernet
connector
Protective cover
Micro-USB (Type AB)
connector (for setting only
.)
E
to open the printer cover.
F
H
so that the paper is set
on page iii.
I
TM-T70-i User's Manual 5
English
Micro SD card
slot ❋
USB connector
(for optional
products)
.
G
Werbung
Inhaltsverzeichnis
