Jbat1: Clear Cmos (Reset Bios) Jumper; Jwb1: Water Block Header - MSI MPG X670E CARBON WIFI Benutzerhandbuch

JBAT1: Clear CMOS (Reset BIOS) Jumper

There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Resetting BIOS to default values
1. Power off the computer and unplug the power cord.
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and Power on the computer.

JWB1: Water Block Header

This header allows you to connect liquid-cooled EK monoblock. In BIOS and MSI
Center, you can monitor water temperature and flow rate of the monoblock. You can
also control the LED effect through Mystic Light function in MSI Center.
⚠
Important
For more details on installation, please refer to https://www.ekwb.com/shop/ek-
quantum-msi-mpg-x670e-carbon-ek-x-d-rgb.
Keep Data
(default)
6
2
Pin Signal Name
1 +5V (for LED)
3 TSENOR DATA
5 +12V (for W_FLOW)
47
Clear CMOS/
Reset BIOS
5
1
Pin Signal Name
2 LED DATA
4 Ground
6 WFLOW DATA