Meaning Of The Error Codes - Philips Saeco INCANTO HD8921/01 Benutzerhandbuch

The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
correctly. Insert the brew
group.
The hot water dispensing
spout is not installed. Insert
the hot water dispensing
INSERT
WATER SPOUT
spout.
If the display shows an error
10
code, check section 'Meaning
of the error codes' to see
what the code on the display
xx
means and what you can do.
The machine cannot be used
when this icon is on the
display.

Meaning of the error codes

Error code Problem
01 The coffee grinder is
blocked
03 - 04 There is a problem
with the brew group.
05 There is a water
circuit problem.
Below you find a list of the error codes that may appear on the display, their
meaning and how to solve the problem. If these solutions do not help to
remove the error code from the display and bring the machine back to
normal working order, contact the Saeco hotline. Contact details can be
found in the warranty booklet or on www.saeco.com/care.
Cause
The coffee exit duct is
clogged.
The brew group is
dirty.
The brew group is not
positioned correctly.
There is air in the
water circuit.
The coffee grounds container
is full. Make sure the machine
is switched on. Then remove
and empty the coffee grounds
container.
The brew group is blocked by
coffee powder. Clean the brew
group.
Insert the drip tray and close
the service door.
Possible solution
Clean the coffee exit duct thoroughly
with the handle of the measuring
spoon or a spoon handle. Switch the
appliance off and on again.
Remove the brew group and clean it
thoroughly (see 'Cleaning the brew
group').
Remove the brew group and reinsert
it. Make sure the two reference signs
on the side match before you slide
the brew group back into the
machine.
Remove and place back the water
tank a couple of times. Make sure
you insert it into the machine
properly. Check if the water tank
compartment is clean.
English
23