Black & Decker HPL108MT Anweisungen Seite 7

If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Variable speed dial
3. Super-lok Tool free accessory clamping lever
TM
4. Battery
5. Work light
6. Sanding base
7. Dust extraction adapter (fig. G - where supplied)
8. Tooled accessory adapter (spacer)
9. Tooled accessory adapter (Fixing bolt)
Accessories
This tool includes some or all of the following accessories.
The performance of your tool depends on the accessory used.
Black & Decker and Piranha accessories are engineered to
high quality standards and designed to enhance the perform-
ance of your tool. By using these accessories you will get the
very best from your tool.
Precision plunge cut saw blade for
wooden materials, soft plastics.
(Part number - X26105-XJ)
Separating, plunge and flush cutting
of wood and soft plastics. Ideal for
working on doors, skirting boards,
windowsills and flooring.
Plunge cut saw blade for wood and
metal. (Part number - X26110-XJ)
Separating, plunge and flush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions,
nails and screws.
Plunge cut saw blade for wood and
metal.
(Part number - X26115-XJ)
Separating, plunge and flush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions.
Segmented saw blade.
(Part number - X26120-XJ)
Long life blade which is ideal for
cutting wood, plastics, thin walled
ferrous and non-ferrous material.
(Original instructions)
Assembly
Fitting and removing the battery (fig. B)
To fit the battery (4), line it up with the receptacle on the
u
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release buttons (12) while
u
at the same time pulling the battery out of the receptacle.
ENGLISH
Rigid scraper.
(Part number - X26135-XJ)
Ideal for removal of hard and soft
material from flat surfaces such as
the removal of vinyl flooring, bonded
carpet adhesive, tile floor adhesive,
grout, paint and varnish.
Flexible scraper.
(Part number - X26140-XJ)
Ideal for removal of elastomer
materials from hard flat surfaces in
difficult to reach areas such as silicon
sealant and other caulking materials.
Carbide grout removal blade.
(Part number - X26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
flat surfaces and for fast stock
removal of wood, chipboard and
fibreglass.
Carbide rasp.
(Part number - X26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and fibreglass.
Sanding Sheets.
Various grades for sanding of wood,
painted and varnished surfaces.
7