For Your Safety - AL-KO SUB 8004 Bedienungsanleitung

Introduction
Please read the operating instructions carefully
before you use the submersible pump to prevent
accidents and ensure the trouble-free operation
of the pump.
Make sure you keep the instructions at hand for
quick reference. If you resell your pump or give it
to another user, please include these instructions
in the sale or the gift.
The following symbols are used in the instruc-
tions:
DANGER
!
This symbol draws your attention to
work processes or operating proce-
dures that have to be carefully observed
in order to prevent serious injury to the
user or another person.
CAUTION
This symbol draws your attention to
information you need to ensure that
your pump is not damaged due to
improper or careless use.
PLEASE NOTE
The information symbol draws your
attention to essential technical require-
ments.

For Your Safety

The submersible pump may only be
connect-ed to an electrical device which
!
is compliant with DIN/VDE 0100, Parts
737, 738 and 702 (swimming pools).
Make sure that fuse protection in the
form of a 10 A automatic cut-out and a
fault current guard circuit with a nominal
fault current of 10/30 mA is installed.
The supply voltage and current specified
!
on the type plate must be identical with
the voltage and current of your electrical
system.
If you need to connect your pump to an
!
extension cord, make sure that the cable
is 3 x 1.5 mm
H07RN-F
DIN 57282/57245. The connector must
be splash-proof. Cable drums must be
completely unwound.
Translation of original user instructions
2 that it corresponds to type
and is compliant
The submersible pump may not be
!
operated by anyone
−
who has not read or does not fully
understand the operating manual or
−
is under the age of 16.
The submersible pump may not be used
!
for any other than its designated use.
Before putting the pump into operation,
make sure that
−
the submersible pump, the electric
cable and the plug are not worn or
damaged and
−
Nobody is near, touching or in the
liquid to be pumped.
Do not operate the submersible pump if
!
it is damaged. Necessary repairs must
be carried out in a qualified AL-KO
service centre.
Never use the electric cable to lift, carry
!
or attach the submersible pump to an-
other object. Do not pull on the cable
when unplugging the pump.
Make sure that the pump is unplugged
!
before
repair or cleaning work. In the event of a
malfunction, immediately unplug the
pump. Make sure that the plug does not
get wet.
Do not attempt to make any changes or
!
modifications to the submersible pump
by yourself. You may endanger your life
or invalidate the warranty.
Use
Designated use
The submersible pump is designed for home use
in your house or garden. Please observe the
technical data given in the instructions before
putting the pump into operation.
Your submersible pump has been designed for
use in the following applications:
−
emptying your cellar or house after a flood,
−
emptying containers or pumping liquid from
one container into another,
with
−
pumping water from wells,
−
aerating garden ponds or artificial brooks
and streams,
−
emptying drains or cisterns (submersible
pumps, types Drain only).
The submersible pump is designed to pump only
the following liquids:
−
clear water,
beginning any maintenance,
GB 1