Cleaning The Appliance - Bosch TDS80 Gebrauchsanleitung

4 Wait until the indicator light (2) stops flashing and remains lit
permanently. Two beeps will be heard.
5 Hold the iron in a horizontal position over an empty sink to
collect the water.
If your appliance is equipped with a "Calc'nClean" container
(18*), place the iron on it.
Warning: the container must only be used to perform
the descaling process. It must not be used as a stand
for the iron while ironing.
6 Press the steam release button (14) for 2 seconds. The
descaling process will start automatically. Warning: boiling
water and steam will be released through the soleplate,
carrying limescale and/or deposits that may be inside.
During the process, a beep will be heard every 5 seconds.
7 After approximately 3 minutes, the iron will stop releasing
steam. A long beep will be heard, indicating that descaling
process has finished. The appliance will switch off
automatically.
8 To clean the soleplate (17), immediately rub off any residue
by running the hot iron over a wet cotton cloth.

2. Cleaning the appliance

Regularly clean your appliance for properly maintenance.
Attention! Burn risk!
1 If the appliance is only slightly soiled, wipe it with a damp
cotton cloth only, and then dry it.
2 If the cloth is synthetic, it may melt due to the high
temperature on the soleplate. Switch the steam off and
rub off any residue immediately with a thickly folded, damp
cotton cloth.
3 To keep the soleplate smooth, you should avoid contact
with hard metal objects. Never use a scouring pad, or
chemicals to clean the soleplate.
* Model dependent
2x
5"
2"
BOS CH
23