Samoa 383 400 Bedienungsanleitung Und Ersatzteile Seite 4

EN
CONFIGURATION
Follow the below instructions to pair your U·vision:
1. Starting from the connecting screen (Fig. 2) press and hold
the power button until "setup" is shown on the screen
(Fig. 3). Release the button.
3. The hose reel number starts to increase automatically.
When the desired hose reel number is shown, press and
release the power button to set it. In case that the desired
hose reel number is missed, press and hold the power
button until the counter restarts.
USING YOUR U·vision
If the unit has been properly configured a short press on
the power button shows on the screen the "ready for use"
mode (Fig. 7).
When the screen is displayed, the backlight is activated
during 10 seconds and then turned off. After 30 seconds
since the display is activated and if there is no transaction
in progress, the unit will turn off to save energy. If the unit
is off press the power button to activate it.
If the screen is on and you want to activate the backlight press
briefly the power button in order to activate it for 10 seconds.
4
838 842 R. 05/23
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Fig. 3
Fig. 5
2. Next the configuration screen is shown automatically
(Fig. 4). The unit remains waiting for the hose reel number
that you want to associate.
4. Once that the hose reel number is set, the screen shows
that the configuration is performed and the unit restarts
(Fig. 5). After restarting the screen shows that the U·vision
is configured and ready to operate (Fig. 6).
In the "ready for use mode" (Fig. 7) are displayed the
product (1) associated to the hose reel, the battery charge
indicator (2), the wireless strength (3) and the hose reel
number (4) paired.
Fig. 4
Fig. 6
Fig. 7