maruyama MD181DX Bedienungsanleitung Seite 9

OPERATION
When the engine has warmed-up, the mist blower can be positioned on the back of the operator.
When the mist blower is positioned and ready for operation, adjust the throttle to a speed required to
accomplish the task.
INTAKE GRILLE
OF THE BLOWER
HOUSING
OPERATING POSITION
WARNING
• Never operate a mist blower when you are fatigued.
• Never operate a mist blower without proper guards or other protective safety devices in place.
WARNING
To prevent overheating and engine seizure, cooling air comes from the intake grille of the fan housing
and is pushed by the blower fan through an opening in the fan housing over the cylinder fin area,
taking away combustion heat. The grille and cylinder fins must be kept clean of grass, dust and any
debris. Engine failure due to lack of this "Normal Maintenance" is not covered by warranty.
1. Mist cock
Open
Stop
Close
Discharging volume
Nozzle holding
position
CAUTION
• Avoid using too dense hydrate solution.
2. Adjustment of discharging volume
mark
• Coincide the number on the dial of volume
switch with the market.
• Discharging volume will increase accordingly as
the number increases.
5
4
3
2
1
0 1 2 3 4
8
Volume switch
The nozzle being
held nlevel
Aperture
(Number on the dial
of volume switch)
5