Kaltmann K-PGB4000EU5 Bedienungsanleitung Seite 39

• Take into account the total power requirement (W) of all connected devices. The power
consumption information is usually located next to the model number or serial number of the
devices.
To power a device vie an AC outlet:
1. Start the engine;
2. turn on the circuit breaker;
3. connect the device.
Most devices need more energy to start up than stated
in their nominal power (W). For this reason, some
devices may put a short load on the generator when started up.
When connecting several devices, connect them in descending order of power consumption
(W). In the event of an overload of the generator, the system circuit breaker will trip
automatically. In this case, reduce the load, wait a few minutes, and then reset the circuit
breaker.
DC Outlet
To recharge a car battery:
1. First connect the positive (+) terminal to the
positive pole of the battery,
2. Then connect the negative (-) terminal of the
black to the negative pole of the battery,
3. To start charging, connect the charging cable to the DC socket.
The DC installation breaker automatically turns off the DC installation when the installation is
overloaded, there is a problem with the battery being charged, or when the connections
between the battery and the generator are incorrect.
The DC circuit breaker button will pop out when the circuit breaker is disabled. Wait a few
minutes and press the button to reset the DC circuit protection.
The DC jack is ONLY for charging 12 V car
batteries.
38