Walmag GP250 Bedienungsanleitung Seite 8

EN
OPERATION
READ THE SAFETY INSTRUCTIONS FIRST BEFORE
OPERATING THE MAGNET.
Check the condition of the magnet each time before use. Wipe
the pole shoes on the magnet and the contact surface of the
workpiece clean. If necessary pile off anyburrs or irregularities.
HORIZONTAL LIFTING
1.
Be sure the lifting eye is unlocked! Determine the center of
gravity of the work piece as accurate as possible. Lower
the magnet carefully on the designated position.
NEVER PUT YOUR HANDS BETWEEN THE MAGNET AND THE
WORKPIECE!
2.
Make sure that release handle is in the locked position.
3. Lift the load several centimeters and give the load a firm
push to ensure that it is well gripped. Never stand under the
load!
4.
Guide the load by holding the corners. Avoid collisions,
swinging and shocks. Never stand under the load and keep
the load horizontal!
5.
Lower the load and stabilize it before removing/breaking
off the magnet. Unlock the release handle and pull the
same to break off the magnet. Now lift the magnet away
from the workpiece.
LIGHT WORKPIECES MAY STILL STICK TO THE MAGNET!
VERTICAL LIFTING
1. Lock the lifting eye in the vertical position.
Unlock the release handle. Determine
the center line near the topedge of the
work piece.
2. Approach the work piece slowly with the magnet and
position the magnet by means of the release handle and
the hoist.
NEVER PUT YOUR HAND BETWEEN THE MAGNET AND THE
WORKPIECE!
3.
Put the release handle in the lockedposition and jerk it
firmly to make sure the magnet is clamped properly. Now lift
the workpiece carefully away fromits support.
THE WORKPIECE WILL SWING AWAY FROM THE SUPPORT.
ALWAYS KEEP A SAFE DISTANCE WHILE BEGINNING TO
LIFT.
Appel Gratuit
0800 33 11 11
4.
Lower the load and stabilize it before removing/breaking
off the magnet. Unlock the release handle and pull the
same to break off the magnet. Now lift the magnet away
from the workpiece.
TURNING WORKPIECES THROUGH 90 °
By locking the lifting eye, the magnet can be used to turn
workpieces from horizontal to vertical and vice versa.
FOR THIS TYPE OF MANIPULATION, THE WORKPIECE
WEIGHT MAY NOT EXCEED THE VERTICAL LIFT CAPACITY.
From horizontal to vertical
1.
Place the magnet on the center line near
the future top edge of the workpiece.
2.
Put the release handlein the locked position.
Jerkit firmly to make sure the magnet is
clamped properly.
3.
Start to lift slowly and follow the turning
of the workpiece by the hoist.
THE WORKPIECE WILL SWING AS SOON AS IT IS NO
LONGER SUPPORTED. KEEP A SAFE DISTANCE!
4.
Lower the load and stabilize it before removing/breaking
off the magnet
5.
Unlock the release handle and pull the same to break off the
magnet. Now lift the magnet away from the workpiece.
From vertical to horizontal
1. Guide the magnet by the unlocked release
handleand the hoist and place it on
the center line near the top edge of
the workpiece.
2. Put the release handlein the locked
position. Jerk it firmly to make
sure the magnet is clamped properly.
3. Start to lift slowly.
THE WORKPIECE MAY SWING AWAY FROM THE SUPPORT.
ALWAYS KEEP A SAFE DISTANCE WHILE BEGINNING TO
LIFT.
4. Lower the workpiece slowly on the horizontal support and
follow the turning ofthe workpiece by the hoist.
Make sure the workpiece is stabilized.
5. Unlock the release handle and pull the same to break off the
magnet. Now lift the magnet away from the workpiece.
LIGHT WORKPIECES MAY STILL STICK TO THE MAGNET.
Web
Otelo.fr commercial@otelo.fr
Email