Precautionary Measures - LEITZ ProfilCut Betriebsanleitung

Risk of injuring due to parts flying off!
The limits for the tool weight, diameter, and projection length recommended by the
machine manufacturer, have to be observed.
Check the machine data, especially RPM and direction of rotation!
Risk of loosening of the tool!
Improper stopping of the tool, e.g. by lateral pressing, is not allowed.
During installation it must be ensured, that the tool and all cutting and spare parts are
mounted on the correct clamping devices.
Cutting parts should not come in to contact with clamping elements or machine parts.
When using stacked tooling ensure that the cutting parts are not in contact with each
other.
All clamping surfaces have to be free of dirt, grease, oil or water.
Tighten clamping screws and nuts by using appropriate mounting tool and the
recommended torque.
The extension of wrenches or the use of hammer blows is not permitted!
5.5

Precautionary measures

Wear safety gloves!
Risk of injury due to sharp cutting edges!
Wear ear protection!
Risk of becoming hard of hearing!
Check the cutting edges, clamping elements, screws and tool bodies regularly for
potential damages – especially after collision of the tool with parts of the machine e.g.
machine table, work piece clamping elements, extraction hood.
Damaged or worn cutting parts, clamping elements or screws have to be replaced set-
wise immediately with original replacement parts.
Damaged tools have to be checked by an expert.
11/2019 ID.524811 V3.0 17