LEITZ ProfilCut Betriebsanleitung Seite 16

Risk of damage!
5.3 Assembly of the tool
When assembling the tool, observe the torque specifications of chapter 8!
Wear safety gloves!
Risk of injury due to sharp cutting edges!
Always mount all parts. Use corresponding parts of the same weight to avoid unbalance.
Cutting parts, seatings and clamping elements shall be free of dirt, e.g. resin, grease, oil
or water.
Screw heads have to be cleaned to guarantee the correct and tight interlocking with the
wrench.
Risk of injuring due to parts flying off!
Tighten clamping screws and nuts by using appropriate mounting tool and the
recommended torque.
The extension of wrenches or the use of hammer blows is not permitted!
5.4 Mounting on the machine
The tool has to be mounted, locked and started up on the machine as per the instructions
of the machine manufacturer.
Starting the machine during the tool change is not allowed (see handling instructions of
the machine).
Wear safety gloves!
Risk of injury due to sharp cutting edges!
Before using the tool check the cutting parts, clamping screws and clamping elements for
correct and tight seating.
16 11/2019 ID.524811 V3.0