Fantec NVMe31-FastLock Montageanleitung Seite 11

07.
Remove the foil from one side and place the thermal pad with the side
without the foil on the NVMe SSD. Press the thermal pad lightly against the
NVMe SSD. The NVMe SSD must not bounce loosely, but must be firmly
clamped under the latch. Now carefully remove the second foil.
1
08.
Slide the housing back together. Orientate yourself by the arrow at the top
rear right. There will most likely be residues of the thermal pad on
the edge of the casing. Wipe these off carefully. If everything is seated
correctly, place the housing back on the table, put the cap back on the open
end slightly offset by 5mm and slide the cap back to the right.
09.
Keep the foil remnants in case you want to remove the NVMe again. To
protect the thermal pad, put one foil back on the thermal pad and carefully
take the pad down together with the foil and then put the pad on the second
foil.
first foil on
thermal pad
FANTEC NVMe31-FastLock
2
Remove Thermal pad
3
second foil on
thermal pad.
EN
11