Safety Cut Out; Pressure Relief Valve - HBM Machines H130004 Bedienungsanleitung

STRIPPING WALLPAPER
Connect one end of the steam hose to the steam plate and the other end of the hose to the outlet on the tank .
Check the connections from time to time between use . Apply steam plate to a small area first to check
for correct operation .
Hold the steam plate against the desired surface for approximately 10 seconds . Then move the plate to the
spot immediately next to the one previously steamed / the paper should now easily come away with help from
a suitable scraper . Working this way should enable continuous paper removal although it may be necessary
to steam for longer periods with some papers , or if not completely removed first time .
TIPS
Heavy duty paper , paper that has been gloss painted and vinyl paper might require scoring to allow the steam
to penetrate into the paper. Operate steamer until water level Is low then unplug the machine and allow the tank
to cool for at least 5 minutes before removing the filler cap - BEWARE OF STEAM-and refill the tank.
When finished allow the machine to cool before emptying the tank , and always store the machine empty .

SAFETY CUT OUT

A safety cut-out is fitted to prevent the element overheating if the water level becomes too low .
If the tank stops boiling during use this may be the cause . Wait for 5 minutes before removing the
filler cap then refill with clean water . The cut-out will reset itself in 15 minutes of cooling and steam
will be produced again .
The cut-out will not protect the element if the tank is tilted during use , which will damage the cut-out
device permanently and make it unable to reset and produce steam again .

PRESSURE RELIEF VALVE

A safety cut-out is fitted to prevent the element overheating if the water level becomes too low .
If the tank stops boiling during use this may be the cause . Wait for 5 minutes before removing the
filler cap then refill with clean water . The cut-out will reset itself in 15 minutes of cooling and steam
will be produced again .
The cut-out will not protect the element if the tank is tilted during use , which will damage the cut-out
device permanently and make it unable to reset and produce steam again .
IMPORTANT :
Unplug the unit and wait for at least 5 minutes before removing
the hose or changing tools .
DESCALING THE TANK
To maintain good performance of the appliance , particularly in areas of hard water ,it may be necessary
to descale the element In the tank . Proprietary kettle descaling products can be used in your appliance-always
follow the manufacturers instructions .
TIPS