Important Safety Instructions - HBM Machines H130004 Bedienungsanleitung

IMPORTANT SAFETY INSTRUCTIONS

Read all instruction before use and keep for future reference .
IMPORTANT INFORMATION ON STEAMING
Keep steam away from plug sockets .
The steam is produced at 100 degrees Celsius , wear protective clothing and protect your hands with
heat resistant gloves.
Never detach the hose or remove the filler cap while the machine is in operation .
Do not pull on hose too hard , move the machine around by using the handle
Do not stand on the machine and try to avoid stepping on the steam hose .
Never cover or block the safety valve
Do not leave the machine unattended while still connected to power supply .
Keep the tank on a flat and level surface while in operation , failure to do so could result in the machine
overheating
Never direct steam hose or steam plate in the direction of anybody .
Always keep steam plate tilted away from face , beware of hot droplets of water especially when
stripping ceilings and high areas
Wait for at least 5 mins after disconnection before removing filler cap
Use only tap water when filling machine , never overfill
Never add any detergent or chemicals to water .
Extreme care must be taken when the appliance is used in bathrooms / kitchens , beware of
electrocution from stored water in baths and sinks
The power must be disconnected before the machine is cleaned , make sure that the power inlet is dry
before reconnection .
WARNING!
Keep steam away from plug sockets .
Misuse or modification of this power tool may result in breakdown or injury .
To reduce the risk of fire or electric shock , do not expose this appliance to rain ormoisture
KNOW YOUR POWER TOOL
It is important that you read and understand your instruction manual and any labels attached
to the power tool . Know the application as well as the limitations and potential hazards
associated with this power tool.
Do not use the tool for purposes for which it is not intended.
Before use carefully check for signs of any damage
Ensure that any switches are in the OFF position before plugging into the mains supply.
Always check that any keys and adjusting wrenches are removed from the power tool before use
Keep any attachments sharp and / or clean for optimal safe performance . Follow instructions for
lubricating and changing accessories.
Keep any handles dry , clean and free from oil and grease
Ensure that any ventilation slots are not covered , kept clean and free from dust at all times
Blocked ventilation slots can cause overheating and damage to the tool.
Ensure that any attachments are securely fixed to the power tool before use . Check the fixings
periodically during use .