Basic Assembly - HBM Machines H130004 Bedienungsanleitung

IMPORTANT!
Please read the important safety instructions before use
NOTE : Always remove the plug from the mains power before fitting
or removing accessories .

Basic Assembly

1 . Connect one end of the Flexible Hose G
to the Steam Outlet Fitting D.
See fig . 1
2 . Connect the other end of the Flexible
Hose G to the Steam Plate F.
See fig . 2
3 . Remove the Filler Cap C . Fill the
Water Tank with clean water preferably
hot water-no higher than the MAX level.
Then replace the filler cap and screw
back on tightly.
See fig 3
NOTE:
Do not over fill the Water Tank or allow
the level to drop below the MIN level.
Do not use any additives or chemicals.
Please ensure the filler cap is fully tightened
before using the Wallpaper Stripper .
ASSEMBLY