Startup And Operation; Startup; Operation; Operating Notes - Balluff BTL7-V50T-M P-SA479-C003-Serie Betriebsanleitung

BTL7-V50T-M _ _ _ _ -P-SA479-C003/ _ _ _ _
Magnetostrictive linear position sensor – Set
6

Startup and operation

6.1

Startup

DANGER
Uncontrolled system movement
When starting up, if the position measuring system is
part of a closed loop system whose parameters have
not yet been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and readjust the position measuring system, if
necessary. Check spacing over the entire measuring
range.
Check for the correct values, especially after
replacing the BTL or after repair by the
manufacturer.
The S.C.A.D.A visualization software is provided
to facilitate the startup process.
This can be used to read off the current position
and error states and perform initialization (see
Fig. 6-1).
This software is intended for the startup
process only.
Fig. 6-1: SCADA software (only for startup)
www.balluff.com
6.2

Operation

NOTICE
Damage due to high induction currents
If welding work is carried out in the immediate vicinity of
components of the BTL7-V50T-...-SA479, high induction
currents can damage the position measuring system.
► Switch off the power supply to the system.
6.3

Operating notes

– Regularly check function of the sensor and all
associated components.
– Take the position measuring system out of operation
whenever there is a malfunction.
– Secure the system against unauthorized use.
– Check fasteners and retighten if needed.
6.4

Maintenance

The product is maintenance-free.
english 11