Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
■Maintenance and inspection
Frequently remove undesirable attachments such as crumbs and oil stains on the tools. Keep
tools clean and knives sharp. Frequently check that the screws at each connection part
should not be loose. Frequently check that the insulation layer of the power cord should
not be damaged.
◆ Replacement of electric brushes:
When the tool has large sparks during operation or stops running, the electric brushes should be
replaced.
Use a screwdriver to unscrew the brush cover, take out the worn brush and install a new brush,
and confirm that the brush slides freely in the hole, and then tighten the brush cover.
Be sure to replace both brushes at the same time.
■Maintenance: If you need to replace the cable and repair, please be sure to hand it over to the
authorized dealer's customer service to avoid endangering the safety of the machine.
1.
Place the connecting block between the two guide rails
2.
The outside of
3.
Locking the connecting block screw
1.
The back connection block is also connected according to the front connection method
2.
After the connection is completed, check the track to ensure that it is on the
the two guide rails is closely bonded with the ruler
same straight line.
Werbung
Inhaltsverzeichnis
