Wiring Diagram; Restore Factory Settings - Orno OR-ZS-804 Bedienungsanleitung

• * Installing and using the doorbell. Connect the doorbell using leads NO2 and COM2. Press #, the lock will send a signal to the doorbell.
Notes:
In zone 2 it is possible to connect a doorbell if it is not necessary to operate the second door. The doorbell is connected via the NO2 and COM2 wires.
Pressing the # button on the keypad will cause the lock to send an activation signal to the doorbell. The doorbell will stop working when the "#" button is released.
Connect the negative pole of the lock to NC /normally closed/, this is a fail-safe lock.
Connect the negative pole of the lock to NO /normally open/, this is the lock that operates in the event of a power failure.
Both relays on the board can operate in pulse mode (useful for access control) or bistable mode (useful for arming/disarming alarms, switching on lights, machines, etc.).
Each time a valid card is used or a PIN is entered in pulse mode, the relay will operate for a pre-set pulse time.
Each time a valid card is used or a PIN is entered in bistable mode, the relay will change its state, and remain in that state until the next time the card or PIN is used.
To restore the factory settings, switch off the power, press and hold
This means that the factory settings have been successfully restored. A long beep will sound when the button is released
Important: restoring the factory settings does not result in the loss of user information.
As a tampering alarm the OR-ZS-804 uses a photoresistor. If the keypad is removed from its cover, the alarm signal is activated.
Operating status
Zone 1, unlocked
Zone 2, unlocked
Power
Readiness
Pressing the button
Operation successful
Operation failed
Entering programming mode
Entered programming mode
Exit programming mode
Alarm
1. administrator settings
To enter the programming mode
To exit from the programming mode
Important: all steps described below must be performed after entering the programming mode
Change of master code

WIRING DIAGRAM

RELAY OPERATION (pulse and bistable mode)

RESTORE FACTORY SETTINGS

, switch on the power. Hold the button down until you hear three beeps (two short, one long).
ANTI-SABOTAGE
AUDIBLE AND OPTICAL SIGNALLING
Red diode
-
-
Bright
Lights up slowly
-
-
-
Bright
Bright
Lights up slowly
Lights up quickly
Programming mode - instruction
0 Master code #
The factory set MASTER code is: 888888
*
0 New code # New code #
The MASTER code contains any 6 digits
Green diode
Bright
-
-
-
-
-
-
-
Bright
-
-
8
.
Blue diode
-
Bright
-
-
-
Bright
- 3x Short call
-
-
-
-
Buzzer
Short call
Short call
Long call
-
Short call
Long call
Long call
-
Long call
Alarm