Wiring Scheme - Orno OR-ZS-820 Bedienungsanleitung

Common power supply:
Attention: install a 1N4004 diode or an equivalent diode, or the reader might get
damaged. (1N4004 diode is included in the packaging).
Function Description
Enter the programming mode
Change the master code
Add card user
Add PIN user
Delete user
Exit from the programming mode
How to be granted access?
Card user
PIN user
General programming information:

User ID number: assign a user ID to the access code in order to keep track of the users of access cards or PINs. The standard user ID number can be
any number from 0-989, and the range of numbers for visitors is 990-999.
IMPORTANT: user IDs do not have to be proceeded with any leading zero. Recording of user ID number is obligatory.

Proximity card: any 125KHz EM proximity card.

Keypad PIN: the PIN can be any 4-6 digits between 0000-999999 (except for 1234 which is reserved).
PROGRAMMING 1 – Keypad configuration
Set master code
The 6 digits master code is used to prevent unauthorized access to the system. To interface with the keypad, the administrator will need a master code (factory default
code: 123456). It is highly recommended to immediately update and record your master code when you use the device for the first time.
Programming step
1. Enter programming mode
2 Update master code
3. Exit programming mode
Set access configuration
There are three types of access configuration for the keypad:

Card or PIN (Default) – the user must read a valid card or enter their PIN code followed by the # key, in order to be granted access.

Card only – the user must read a valid card in order to be granted access.

Card + PIN – the user must first read a valid card and then enter their PIN code followed by the # key, in order to be granted access.
Programming step
1. Enter programming mode
2. Card or PIN
OR
2.Card + PIN
OR
2.Card only
3. Exit programming mode
Set relay configuration
The relay configuration sets the behavior of the output relay on activation.
Programming step
1. Enter programming mode
2 Pulse mode
OR
Latch mode
3 Exit

WIRING SCHEME

Access control power supply:
SIMPLIFIED INSTRUCTION
Operation
*(master code
(123456 is the default master code)
0 (New master code) #
(repeat new master code) #
(code:6 digits)
1 (Read card)
1 (User ID) # (PIN) #
The ID number is any number between 0-989. The PIN is any 4-6 digits between
0000-999999; except for 1234 which is reserved
2 (Read card)
2 (User ID) #
*
Read card
Enter (PIN)#
PROGRAMMING
Keystroke combination
*(Master code) #
0 (New master code) #
(Repeat new master code) #
*
Keystroke combination
*(Master code) #
3 0 # (factory default)
3 1 #
3 2 #
*
Keystroke combination
*(Master code) #
4 (1-99) #
The relay time is 1-99 seconds.
(1 is 50mS). Default is 5 seconds.
4 0 #
Sets the relay to ON/OFF latch mode
*
6