Troubleshooting; Troubleshooting Table - Inventum IVW6040AXL Benutzerhandbuch

8

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.

TROUBLESHOOTING TABLE

Problem
The program does not start.
A function indicator is on and the
display goes on and off.
The detergent reservoir contains
detergent residues.
The appliance contains water when
the program is finished.
The appliance stops during a
program.
The appliance makes unusual
sounds during a program.
There is food waste left on the
dishes.
Possible cause
The mains plug is not connected.
There is a problem with the fuse.
There is no water supply.
The door of the appliance is open.
The appliance is switched off.
The water inlet hose and filters are
clogged.
The door is open.
The detergent reservoir is filled while
the reservoir was still damp.
The drain hose is clogged or twisted. •
The filters are clogged.
The program has not finished.
There is a power failure.
There is a water inlet failure.
The program is paused.
The appliance is not loaded
correctly.
One of the spray arms hits the
dishes.
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
The cutlery basket is too full.
'Resetting the program'
Possible solution
Connect the mains plug.
Do a check on the fuse box.
Open the water tap.
Close the door.
Start the appliance. Refer to section
'Starting the appliance'
.
Make sure that the water inlet hose
and the filters are not clogged.
Close the door.
Make sure that you fill the detergent
reservoir when it is dry.
Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
Clean the filters. Refer to section
'Cleaning the filters' .
Wait until the program is finished.
A buzzer sounds five times when the
program is finished.
Make sure that there is power.
Make sure that there is water inlet
supply.
Start the program.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
English
.
• 49